Gerber ODYSSEY XP Owner's Manual page 73

6 If dust or debris is detected (
( <Front> or <Back> ), properly clean as described below.
7 If dust or debris is detected in any of the other sensors, used canned
air to gently blow air through the sensor to remove dust.
8 If the sensors are clean, press ENTER twice to return to the Main
Menu.
As Required
Debris or small amounts of vinyl adhesive can build up on the lens of an
edge sensor and cause false readings. Symptoms include failure to detect
an edge, misalignment, and tracking errors.
To clean an edge sensor
CAUTION: Turn off power to the plotter before cleaning the sensor.
Alcohol can damage the sensor if power is present. Wait until all
alcohol has evaporated before turning power back on.
Control
panel
(This view is from the rear of the plotter looking over the
1 Turn off power to the plotter.
2 Place one or two drops of isopropyl alcohol on the end of a cotton
swab stick. DO NOT soak the cotton with alcohol.
3 Carefully wipe the lens of the edge sensor. The alcohol should
dissolve adhesives and remove stuck debris.
4 Allow several minutes for the alcohol to evaporate and the edge
sensor to dry.
Dust/Object Detected ) in an edge sensor
Edge sensor
Edge sensor lens
top of the plotter and down.)
67
Deflector