Gerber ODYSSEY XP Owner's Manual page 29

To run a single job
1 Press F2 to toggle between Single and Multi mode. Choose Single.
F2
Mode: Single
Job Status:
2 Load the material in the plotter.
3 Install a tool in the tool holder.
4 Use the slew keys to move the tool to the starting position of the job.
5 Send the job from your computer to the plotter. When the job is in
plotter memory, the status changes from
blinks (indicated by the dotted box around Start-Job in the diagram).
MAIN MENU
F1
Start-Job
Mode: Single
Job Status:
6 Press F1, Start-Job, and verify that the correct material is loaded in the
plotter. This display does not appear if the Plotter Prompts checkbox
is not turned on in Gerber software.
Job: PLT1474.plt
Color: White
Press F4 key - >
7 Press F4. The job starts and Job Status displays
DONE. (The percentage appears only with OMEGA and GA version 6.2
or higher.)
F1
Pause-Job
Mode: Single
Job Status: Running % DONE
To pause and re-start the job, press F1.
MAIN MENU
Settings
Menu 1
No Job
No Job
Settings
Menu 1
Ready
Type: 220
MAIN MENU
Settings
23
to Ready , and Start-Job
Running and ## %