Table of Contents
Advertisement
To help you locate and align the grit and pinch wheels, there is a
measuring scale on the platen. Use the lower scale inch readings for
material up to 25" wide. Use the upper scale inch readings for material
more than 25" (64 cm) wide. When you slide the material width
adjustment handle to set the grit wheels for the material width, both the
left and center grit wheels move as a unit. When you slide the pinch
wheels, both the left and center pinch wheels move as a unit.
CAUTION: Raise the pinch wheels off the grit wheels (push the pinch
wheel lever toward the back) when the ODYSSEY XP is not in use.
This prevents creating flat spots on the wheels.
To load material into the plotter
Tip: Use the left and right slew keys on the control panel to move the carriage
near the center to make loading material easier. For information on using the
slew keys, refer to "Learning the control panel" on page 20.
1 Raise the pinch wheels off the grit wheels by pushing the pinch wheel
lever toward the back.
Pinch wheel lever
Pinch wheels
with grit wheels
underneath
Measuring scale
9
Material (width)
sensors
Right pinch
and grit wheel
Alignment
mark
Edge sensor
and deflector
Hide quick links:
Advertisement
Table of Contents
