Gerber ODYSSEY XP Owner's Manual page 69

Symptom
Pinch Wheel Error
Pinch wheel too far
from material edge
Pinch wheels are up
No power
Poor cut quality
Poor performance
System error code number
Thick and thin strokes
Tool is missing
Tool latch binds
Wide material:
DROP pressure lever
on middle pinch wheel
Recommended Procedure
Pinch wheels are in the wrong position. Slide grit
wheels and pinch wheels to place one pinch wheel
one-half inch from material edge.
Move pinch wheel lever to lower the pinch wheels.
Check power cable, plugs, fuses, and ON/OFF switch.
Clean grit wheels.
Check knife settings (speed, force, acceleration, and
corners).
Adjust or replace knife blade.
Check plastic cutting strip located on the X axis.
Clean grit wheels.
Perform routine cleaning and lubrication.
Check corners and force settings.
Check blade exposure.
See "Error codes" beginning on page 59.
Check in this order:
1 Material alignment
2 Blade exposure
3 The blade should swivel freely and not wobble in
the knife tool.
Verify that the tool is properly loaded.
You can choose to ignore the warning without a
problem. The warning occurs only once. After the
warning, the plotter waits for you to start the job,
cancel the job, or insert a tool
Apply a light coating of grease on the male part of the
door latch mechanism.
Incorrect pressure on middle pinch wheel.
Lower the pinch wheel pressure lever.
63