Gerber ODYSSEY XP Owner's Manual page 72

66 CHAPTER 7
Maintenance
Carriage
To clean the carriage
1 Remove any tool installed in the tool head
2 With canned air, gently blow clean the carriage to remove paper dust.
Edge sensors
Use the Clean? menu function to determine if sensors need to be cleaned.
To determine if the sensors need to be cleaned
1 Remove all material from the plotter.
2 Ensure that the pinch wheel lever is in the up (open) position.
3 In the Main Menu, Press F4, Menu 1.
Start-Job
Mode: Single
Job Status:
4 Press F3, Clean?
5 The ODYSSEY XP checks each of the sensors. Initially, if a problem is
detected, the plotter provides instructions to ensure that material has
been removed and/or that the pinch wheels are up. Follow the
directions on the control panel display to continue.
MAIN MENU
Settings
Ready
MENU 1
Cut Area
Measure
Enter for Main Menu
Spray air
F3
Menu 1
F4
Clean? F3
Skew
F4