Gerber ODYSSEY XP Owner's Manual page 43

There are three ways to change the corners
♦
the first way is to make the choice in Gerber software
♦
the second way is to make quick, incremental changes at the plotter
control panel (like changing the darkness on a copy machine)
♦
the third way is to make specific numeric changes at the plotter
control panel
To make changes in Gerber software
Open the Plotter Settings dialog box in GAPlot32/GSPPlot and use the
slide control to make the corner sharpness change.
To make incremental corner changes at the plotter control
panel
1 On the Settings menu, press F2, Corners.
SETTINGS MENU
(Default)
Corners
F2
* ScotchCal220 *
The corners adjustment in the example at
the left is too large.
The plotter cuts too far beyond the
corner. What should be a square corner
is actually slightly extended.
The corners adjustment in the example at
the left is too small.
The plotter did not cut far enough before
turning the corner. What should be a
square corner is slightly rounded.
Material
Force
37