Gerber ODYSSEY XP Owner's Manual page 37

If the Use Settings check box is turned off in Gerber software, the rule set
in the ODYSSEY XP control panel is used. Rule set selection in the
ODYSSEY XP can ignore the rule set included with the job. This
condition is used for spool files, which can have embedded rules.
Selection is made on the Operational Setup menu, System, Rules, Select
Rule Usage menu.
♦
If set to When Received, Gerber software overrides the rule set in the
plotter for this job.
♦
If set to Never, the plotter ignores embedded rules and permits an
operator to use a different rule set for the job.
Remember, control panel setting changes:
♦
are retained even after the power has been shut off.
♦
apply only to the currently selected material.
♦
are overridden by Gerber software during the job unless the plotter
Rules Setting is set to
Note: Rule sets are part of the job sent from Gerber software. They remain in
effect for that job unless you modify the job in GAPlot32/GSPPlot. Settings
made at the plotter are associated with the current material selected. If settings
are modified at the plotter during a job, they are stored in the plotter even after
the job ends.
To select which set of rules is used
1 Select the Operational Setup menu by pressing F3 while holding down
ENTER.
2 Press F3, System.
OPERATIONAL SETUP
Settings
ENTER for Main Menu
3 Press F4, Rules.
SYSTEM PARAMETERS
Comm.
HPGL Units
ENTER for Main Menu
Never or turned off from the plot program.
System
Misc.
Version
Rules
31
F3
F4