Gerber ODYSSEY XP Owner's Manual page 66

60 CHAPTER 6
Troubleshooting
Error / Failure
15 Z axis power,
encoder or wiring
failure
16 X axis encoder
failure
17 X2 axis encoder
failure
18 Y axis encoder
failure
19 Z axis encoder
failure
20 Y axis overcurrent
21 Servo system fault
22 X axis drift
23 X2 axis drift
24 Y axis drift
25 Z axis drift
26 ? axis drift
27 Bad control printed
circuit board
version
28 Unknown plot data
29 Plotter overheated
30 Unexpected
interrupt
31 Unknown interrupt
Meaning
Check Z axis encoder
and power connectors.
Check X axis encoder
connector.
Check X2 axis encoder
connector.
Check encoder
connector.
Check encoder
connector.
Carriage left/right
motion is jammed or
obstructed.
SYSOK line at wrong
logic level.
Motion along axis is
jammed or obstructed.
Motion along axis is
jammed or obstructed.
Carriage left/right
motion is jammed or
obstructed.
Tool up/down motion is
jammed or obstructed.
Unused test
Incompatible driver
board.
Plot data corrupted in
plotter.
Temperature inside the
plotter is too hot.
Electrical control board
failure.
Electrical control board
failure.
Correction
Contact Field Service.
Contact Field Service.
Contact Field Service.
Check for obstructions. Retry.
Call Field Service if retry fails.
Check for obstructions and
retry.
Call Field Service if retry fails.
Clear the Y axis jam. Retry.
Call Field Service if retry fails.
Contact Field Service.
Clear the jam. Retry. Call Field
Service if retry fails.
Clear the jam. Retry. Call Field
Service if retry fails.
Clear the Y axis jam. Retry.
Call Field Service if retry fails.
Clear the Z axis jam. Retry.
Call Field Service if retry fails.
N/A
Contact Field Service.
Re-send job.
Power off, let cool. Power on.
Check for running fan and
clear air vents.
Call Field Service if retry fails.
Call Field Service if retry fails.