Gerber ODYSSEY XP Owner's Manual page 17

7 Pull the pinch wheel lever toward the front to clamp the material
between the grit and pinch wheels.
8 The control panel displays the following:
9 Press either F1 (sheet) or F3 (roll) to select the material type. For
information on using the F1, F2, F3, and F4 function keys, refer to
"Learning the control panel" on page 20.
Note: After pulldown (See page 43), the Odyssey XP will return the material to
the starting position. Do not rewind the surplus material. Allow it to drape over
the dampener bar which promotes a smooth material feed to the cutting tool.
Dampener bar
Material path before pulldown
Verifying the material alignment
After you load the material, run auto alignment. The time to perform this
process varies with the amount of error detected.
To perform the material alignment sequence
1 When the display shows
2 The display shows
pinch wheels.
3 The display changes to
material is moved back and forth as the edge is aligned.
4 When the material is properly aligned, the Main Menu appears.
SELECT MATERIAL TYPE
Sheet
Press F1 or F3
Auto Align Material?
Locating Pinch Wheels
Material Auto Align in Progress
Roll
Material path after pulldown
, press F3 (Yes).
while the carriage locates the
while the
11