Getting Help; Conventions Used In This Manual - Gerber EDGE 2 Owner's Manual

CHAPTER 1
2
Introduction
Installing the EDGE 2 into your software gives the procedures for
installing the EDGE 2 into Gerber's GRAPHIX ADVANTAGE®
software.
Material handling describes how to put a roll of vinyl onto the tensioner
assembly, load the vinyl into the EDGE 2, and position it correctly. It also
describes the procedure for loading and unloading a foil cartridge.
Operating the EDGE 2 describes the controls on the EDGE 2 keypad,
how to print a job from GRAPHIX ADVANTAGE, and how to print old
GA™ files that were created for the original EDGE or in a version of GA
prior to 4.3.
Troubleshooting provides guidelines for responding to error messages
that appear on the EDGE 2 display and how to correct typical printing
problems.
Maintenance describes basic cleaning procedures that must be
performed to provide the best print quality and keep the EDGE 2 in
operating condition.

Getting Help

If you require assistance, please contact your Gerber distributor or
contact the Gerber Field Service Department at:
800-828-5406 (USA and Canada)
860-643-1515 (International)
860-645-2448 (fax)

e-mail: gsptech@gspinc.com
www.gspinc.com

Conventions used in this manual

The following conventions are used in this manual:
Note: A note contains important information which could affect successful
completion of a task.
A tip is a hint to help you do something more efficiently or quickly.