Table of Contents
Advertisement
2-24
AP-51xx Access Point Product Reference Guide
The LEDs on the rear of the AP-5131 are viewed using a single (customer installed) extended
lightpipe, adjusted as required to suit above the ceiling installations. The LEDs displayed using the
lightpipe have the following color display and functionality:
Boot and Power Status
Error Conditions
Power and Error
Conditions
2.9 Mounting an AP-5181
The AP-5181 can be connected to a pole or attach to a wall. Choose one of the following mounting
options based on the physical environment of the coverage area. Do not mount the AP-5181 in a
location that has not been approved in a site survey.
Refer to the following, depending on how you intend to mount the AP-5181:
•
AP-5181 Pole Mounted Installations
•
AP-5181 Wall Mounted Installations
2.9.1 AP-5181 Pole Mounted Installations
Complete the following steps to mount the AP-5181 to a (1.5 to 18 inch diameter) steel pole or tube
(using the mounting bracket):
1. Fit the edges of the V-shaped clamp parts into the slots on the flat side of the rectangular
plate.
2. Place the V-shaped bracket clamp parts around the pole and tighten the nuts just enough to
hold the bracket to the pole. (The bracket may need to be rotated around the pole during the
antenna alignment process).
Solid white indicates the AP-5131 is adequately powered.
Solid red indicates the AP-5131 is experiencing a problem condition requiring
immediate attention.
Blinking red indicates the AP-5131 Rogue AP Detection feature has located a
rogue device
Advertisement
Table of Contents
