Table of Contents
Advertisement
8-176
AP-51xx Access Point Product Reference Guide
AP51xx>admin(system.snmp.traps)> set
Description:
Sets SNMP trap parameters.
Syntax:
set mu-assoc
mu-unassoc
mu-deny-assoc
mu-deny-auth
snmp-auth
snmp-acl
port
dos-attack
dyndns-update
interval
cold
cfg
rogue-ap
ap-radar
wpa-counter
hotspot-mu-status enable/disable
vlan
lan-monitor
rate
min-pkt
For information on configuring SNMP traps using the applet (GUI), see
enable/disable
enable/disable
enable/disable
enable/disable
enable/disable
enable/disable
enable/disable
enable/disable
enable/disable
<rate>
enable/disable
enable/disable
enable/disable
enable/disable
enable/disable
enable/disable
enable/disable
<rate>
<scope>
<pkt>
Enables/disables the MU associated trap.
Enables/disables the MU unassociated trap.
Enables/disables the MU association denied trap.
Enables/disables the MU authentication denied trap.
Enables/disables the authentication failure trap.
Enables/disables the SNMP ACL violation trap.
Enables/disables the physical port status trap.
Enables/disables the denial of service trap.
Enables/disables dyndns update trap.
Sets denial of service trap interval.
Enables/disables the system cold start trap.
Enables/disables a configuration changes trap.
Enables/disables a trap when a rogue-ap is detected.
Enables/disables the AP Radar Detection trap.
Enables/disables the WPA counter measure trap.
Enables/disables the hotspot mu status trap.
Enables/disables VLAN traps.
Enables/disables LAN monitor traps.
<value>
Sets the particular <rate> to monitor to <value> given the
indicated <scope>. See table below for information on the
possible values for <rate>, <scope>, and <value>.
Sets the minimum number of packets required for rate traps
to fire (1-65535).
Configuring Specific SNMP Traps on page
4-34.
Advertisement
Table of Contents
