Mounting An Ap 7181; Pole Mounted Installations; Installing An Ap 7181 - Motorola AP 7181 Installation Manual

Installation Guide

2.9 Mounting an AP 7181

The AP 7181 Access Point is designed for outdoor installations. All hardware installations should be performed by
a professional installer.
Devices can be deployed using either the

2.9.1 Pole Mounted Installations

The optional wall gooseneck can also be used with the pole adapter for pole mounting.
The wall gooseneck dimensions are 10x12x6 inches and it weighs 4 pounds. The pole adapter dimensions are
4x2.62x7 inches and it weighs 3 pounds.
The gooseneck attaches to the yoke, which can be attached to the top or the bottom of the AP 7181. Secure the
gooseneck and adaptor to the pole with the threaded portion pointing either up or down using band clamps.
If using a bottom mount, drill a 1/2 inch diameter hole at the lowest point on the bend to allow water to drain from
the gooseneck.

2.10 Installing an AP 7181

The following guidelines and procedures should be observed when installing an AP 7181 Access Point.
The following is a list of the minimal tool set required to install an AP 7181 device:
• 24 mm socket and driver - for cable gland
• 22 mm socket and driver - for GE1 and GE2 port caps
• 19 mm socket and driver - for console port cap
• 21 mm socket and driver - for set screw
• 8 mm socket and driver - for grounding screw
• 6 mm allen wrench bit - for mounting bracket (yoke)
• T27 Torx bit - for the radome antenna panels and sun shields
• Torque screwdriver - for the radome antenna panels and sun shields
• Torque wrench
Bottom Mount Installation Top Mount Installation
or the
15
procedure.