Table of Contents
Advertisement
9-40
AP-51xx Access Point Product Reference Guide
each one of them. If you don't, the base bridge configuration file could get applied on a client bridge
or repeater and you will loose connectivity to that AP.
Mesh Deployment Issue 13 - Why do I lose connectivity when updating
configurations?
When I make a configuration change and apply the changes on a client bridge or repeater, I
momentarily loose connectivity to that AP, why?
Resolution
That is expected behavior, when you make a configuration change on a mesh supported AP, it brings
the radio driver down and then back up again. Consequently, the AP needs to re-establish its mesh
connection after saving the configuration.
Mesh Deployment Issue 14 - Will an existing client bridge see a new base bridge
or repeater?
If I add a new base bridge or repeater to an existing mesh topology, will my current client bridges see
it and connect to it?
Resolution
Yes, all client bridges perform periodic background scanning - both passively (by sniffing the air for
beacons) and actively (by sending Probe Requests). Therefore, a client bridge automatically detects
the presence of a new base bridge or repeater added to the mesh network topology and forms a seam
less connection without affecting current operation.
Mesh Deployment Issue 15 - Can a mesh supported AP react to changing RF
conditions?
If RF conditions change, will a mesh supported AP automatically detect and re-route traffic on its
backup link or look for new links if all current links are exhausted?
Resolution
Yes, all mesh nodes have built in dynamic link switching and auto-recovery mechanisms that ensure
they adapt to changing RF conditions.
Advertisement
Table of Contents
