Table of Contents
Advertisement
2. Refer to the access point
The access point Router Table field displays a list of connected routes between an enabled
subnet and the router. These routes can be changed by modifying the IP address and subnet
masks of the enabled subnets.
The information in the access point Router Table is dynamically generated from settings
applied on the
mask (or network mask) and gateway settings are those belonging to each subnet. Displayed
interfaces are those associated with destination IP addresses. To change any of the network
address information within the WAN screen, see
3. From the
Use Default Gateway
LANs (if enabled) to server as the default gateway to forward data packets from one network
to another.
4. To set or view the RIP configuration, click the
Routing Information Protocol (RIP) is an interior gateway protocol that specifies how routers
exchange routing-table information. The Router screen also allows the administrator to
select the type of RIP and the type of RIP authentication used by the switch. For more
information on configuring RIP, see
5. Use the
User Defined Routes
The User Defined Routes field allows the administrator to view, add or delete internal static
(dedicated) routes.
a. Click the
b. Highlight an entry and click the
c. Specify the destination IP address, subnet mask, and gateway information for the
internal static route.
d. Select an enabled subnet from the
the table entry. Information in the
65535) used by router protocols to determine the best hop routes.
6. Click the
Apply
7. Click
Logout
logout before the applet is closed.
5.4.1 Setting the RIP Configuration
To set the RIP configuration:
Router Table
WAN
screen. The destination for each subnet is its IP address. The subnet
drop-down menu, select the WAN or either of the two
field to add or delete static routes.
Add
button to create a new table entry.
button to save the changes.
to securely exit the access point applet. A prompt displays confirming the
field to view existing routes.
Configuring WAN Settings on page
RIP Configuration
Setting the RIP Configuration on page
Del
(delete) button to remove an entry.
Interface(s)
column's drop-down menu to complete
Metric
column is a user-defined value (from 1 to
Network Management
5-16.
button.
5-67.
5-67
Advertisement
Table of Contents
