Suspend To Disk (Std) - EUROCOM DeskNote 2100P User Manual

Suspend To Disk (STD)

Suspend to Disk is a 0-volt suspend mode for system power management.
STD mode saves more amount of power than POS mode but takes longer
time to return to full operation.
1. Use your operating system's FDISK program to delete all partitions of the
hard disk if any already exist on the target drive.
2. Boot the system from the drive A: and run the 0VMAKFIL.EXE Utility to
create the Suspend to Disk partition on the hard disk. The size of the
Suspend to Disk will accommodate the installed DRAM (n) plus 4MB
or 8MB integrated video RAM.
For example, if the system DRAM is 32MB, 0VMAKFIL will create a partition
size of approximately 36MB.
Note: Rewrite the sector signatures if you need to partition the hard disk
again.
3. Use your FDISK program operating system to Re-partition the hard disk.
Resume from the STD Mode
The system may be resumed from Suspend-To-Disk mode by:
m Power back on
m Alarm resume (month/day/hour/minute): The system will resume at the
specified time.
2-28 User's Manual
A:\>0VMAKFIL —Pn
A:\>0VMAKFIL —P32
C:\>0VMAKFIL —PW