Step 2: Installing Vga Driver - EUROCOM DeskNote 2100P User Manual

Step 2: Installing VGA Driver

m Click "My computer"Õ"Control Panel"Õ"Display"Õ"Settings".
m Choose "Display Type" Õ "Change" Õ"Have Disk" Õ "Browse "
m Specify the location as: \Ati-vga\vga_nt\534-b12\Disk1. Browse the
location again but change the directory Disk1 to Disk2 as:
\Ati-vga\vga_nt\534-b12\Disk2.
1. From the driver disk, find out the file and open, "Ati_vga".
Click "vga_nt", "534-b12" and choose "Disk1" Õ"Nt40" Õ"atirage".
2.
3. Open the file; click "Ok" and choose "ATI 3D RAGELT PRO AGP
2X".
4. Click "Ok", "Yes", Ok", "Close " and "Yes". Restart the system,
pressing "Ok".
m After restarting, change the display resolution.
m Go to "My computer"Õ"Control Panel"Õ"Display"Õ"Settings".
Change the display resolution into 1024 by 768 pixel. Click "Test" and
see whether the bitmap is properly. If yes, click "Yes", "Apply", "Ok".
Thus, the test has finished.
Note: The VGA driver will fail to install when Service Pack3 is not installed.
4-24 User's Manual