Fabric Sliding Sheet And Vacuum Plate; Adjusting The Height Of The Vacuum Plate - Duerkopp Adler 745-34 Service Instructions Manual
Sewing unit for runstitching of piped flap and welt pocket openings and pocket corners working methods: a, b, d, f
Hide thumbs
Also See for 745-34:
- Operating instructions and replacement parts manual (92 pages) ,
- Installation instructions manual (24 pages) ,
- Spare parts (167 pages)
Table of Contents
Advertisement
10. Fabric sliding sheet and vacuum plate
10.1 Adjusting the height of the vacuum plate
1
Standard checking
The vacuum plate should be on one level with the table top.
–
Lift the fabric sliding sheets 1 at the front and swivel them to the
left.
–
Check the height of the vacuum plate as to the table top.
Caution: Danger of injury !
Switch off the main switch.
Adjust the vacuum plate only with the sewing unit switched off.
The vacuum plate is connected with the table plate support by four
core pins 2.
–
Turn the core pin 2.
Clockwise
Counter-clockwise
–
Readjust the support bolts 7.
3
= Vacuum plate higher
= Vacuum plate lower
2
83
Advertisement
Table of Contents
