Removing / Installing The Switching Cylinder - Duerkopp Adler 745-34 Service Instructions Manual
Sewing unit for runstitching of piped flap and welt pocket openings and pocket corners working methods: a, b, d, f
Hide thumbs
Also See for 745-34:
- Operating instructions and replacement parts manual (92 pages) ,
- Installation instructions manual (24 pages) ,
- Spare parts (167 pages)
Table of Contents
Advertisement
2.6.2
Removing / Installing the switching cylinder
5
4
3
2
1
Caution: Danger of injury !
Switch off the main switch.
Remove and mount the switching cylinder only with the
sewing unit switched off.
Removing the switching cylinder
–
Pull off the pneumatic hoses 3 and 4.
–
Screw the hose connections 2 out of the cylinder.
–
Remove the driving motor (see chapter 2.6.1).
–
Loosen the clamping screw 6 between switching cylinder and drive
shaft.
–
Pull the switching cylinder out upwards.
Installing the switching cylinder
–
Insert the switching cylinder from above.
–
Tighten the clamping screw 6 between switching cylinder and drive
shaft.
–
Push the motor to the front and push the motor shaft into the
eccentric 1.
–
Screw the motor tight with the fastening screws 5.
–
Tighten the screws at the eccentric 1.
–
Screw the pneumatic connections into the cylinder.
–
Push on the pneumatic hoses 3 and 4.
–
Mount the driving motor (see chapter 2.6.1).
6
41
Advertisement
Table of Contents
