Aligning The Flap Turning Device As To The Feeding Device And To The Sewing Level - Duerkopp Adler 745-34 Service Instructions Manual

13.6.3 Aligning the flap turning device as to the feeding device and to the sewing level

1
7
2 8
The feeding device of working method B must transfer the flap
5
precisely into the flap clamp 1 of the feeding clamp.
Pick-up folder, folder, feeding clamps and sewing equipment must be
adjusted in such a way that a good sewing result is already achieved.
The flap turning device cannot compensate errors of the feeding
device of working method B.
Mounting the flap turning device
–
Screw on the flap turning device in the center of the slotted holes
of the folding station plate by means of the screws 2, 3 and 4.
Make sure that the thrust bolts 5, 6 and 7 have no pretension.
6
Aligning the flap clamp of the flap turning device as to the
measuring line "125"
–
Loosen the screws 1 and 2.
–
Align the stationary and the movable flap clamp parallel to the
measuring line "125".
–
Tighten the screws 1 and 2.
1
4 3 2
121