Adjusting The Slant Of The Corner Incisions - Duerkopp Adler 745-34 Service Instructions Manual
Sewing unit for runstitching of piped flap and welt pocket openings and pocket corners working methods: a, b, d, f
Hide thumbs
Also See for 745-34:
- Operating instructions and replacement parts manual (92 pages) ,
- Installation instructions manual (24 pages) ,
- Spare parts (167 pages)
Table of Contents
Advertisement
5.4
Adjusting the slant of the corner incisions
6
2
72
Caution: Danger of injury !
Switch off the main switch.
Adjust the corner knives only with the sewing unit switched off.
Standard checking
The incisions of the corner knives should be as close to the seam as
possible, but must not cut it.
–
Adjust the maximum sewing length at the control.
–
Sew a test seam.
It is advisable to iron a piece of interfacing on the workpiece
before. By this the corner incisions become better visible.
–
Check seam and cutting pattern.
–
Loosen screw 6.
–
Adjust the corner knife holder 2 correspondingly.
–
Tighten screw 6.
–
Adjust the other three knife holders according to the seam pattern.
Advertisement
Table of Contents
