Removing The Lever Assy.,Eject; Figure 3-19. Removing The Lever Assy.,Eject - Epson DLQ-3000 Service Manual

Removing the LEVER ASSY.,EJECT

3.2.6.9
Remove two EXTENSION SPRING~53 from both ends of the LEVER ASSY., EJECT.
Step 1 :
Remove the SENSOR ASSY.,LOAD. (Refer to Section 3.2.6.3.)
Step 2:
Remove the E ring (#3) which fixes the LEVER ASSY.,EJECT to the FRAME,ASSY.,
Step 3 :
RIGHT.
Move the LEVER ASSY.,EJECT to the left. Then remove it from both ends of the
Step 4:
FRAME.
E

Figure 3-19. Removing the LEVER ASSY.,EJECT

3.2.6.10 Remove the CARRIAGE ASSY.
Remove the printer mechanism. (Refer to Section 3.2.6.1.)
Step 1 :
Pulling the two notches on the HOLDER,HEAD,CABLE outward, pull up the
Step 2 :
HOLDER, HEAD,CABLE (with FFCS) from the FRAME,CR.
Remove the FFCS from the HOLDER,HEAD,CABLE.
Step 3 :
Figure 3-20. Removing the HOLDER,HEAD,CABLE
Rev. A
HOLDER, HEAD, CABLE
Disassembly and Assembly
3-17