Epson DLQ-3000 Service Manual page 93

Adjustment
Add Function
FONT
Pitch
Character Table
Page Length Tractor
Line Spacing
Top Margin Tractor
Manual Insertion
Bottom Margin Tractor
Left Margin
Right Margin
Copy Mode
These settings are the factory defaults programmed into this printer.
Press the Y and the Enter key to confirm these settings and return to the initial menu.
Step 11 :
Exit the program by pressing 3 and the Enter key.
Step 12:
The following message appears on the display:
Step 13:
Any setting value specified within this program
is not stored in the EEPROM until you turn the printer OFF.
Turn the printer off to store the defaults shown in the table into the EEPROM on the
Step 14:
main board.
Note: If you have replaced the main board, you must also perform the bi-directional a@stment
procedure after competing this procedure.
4-6
Table 4-3. Default Setting
I
SW& Valid
Roman
11 inch
A4
0.33 inch (8.5 mm)
0.33 inch (8.5 mm)
0.33 inch (8.5 mm)
0.00 inch (0.0 mm)
O column
136 columns
copy 1
Turn the printer OFF now.
Add Function
Graphic Print Direction
Software
If
Interface
Interface Auto
Selection Timeout
Serial Interface Baud
Rate
Parity
Auto Tear-off
Auto LF
Auto CR
AGM
SW&Valid
I
I
Auto Selection
10
sec.
19200 bps
None
OFF
OFF
OFF
OFF
Rev. A