5.2.1.2
Program Selection via Menu
5.2.1.3
Side Selection in a Program
If the program number is unknown, all programs can be run through
sequentially in the following manner.
Order of operations
–
Press the "P" key.
Change-over to the "Program Selection" mode.
–
Press the "Y" key.
The first program is shown.
Each pressing of the "Y" key moves to and shows the next
program.
If the program has valid data assigned to it, the following display
appears:
If the program has no valid data assigned to it, the following
appears:
–
If the displayed program is to be selected,
press the "E" key. (Example: Program 01)
The following display appears.
After selection of a program one always goes first to the right piece (if
a right sleeve has been programmed).
In the automatic mode one can, however, alternate between "right" and
"left" sleeves at any time.
–
Press the "E" key.
The controls switch to the left sleeve.
The display shows:
–
Press the "E" key again.
The controls switch to the right sleeve again.
The display shows:
1
21