Drive Shaft Position - Duerkopp Adler 910 Service Instructions Manual

5.2 Drive shaft position

18,5 mm
2
28
1
Caution: danger of injury!
Turn off the main switch.
Check and adjust drive shaft only when the sewing unit is switched off.
Important
In its resting position, the drive shaft 1 should be 18.5 mm distant from
the front edge of the throat plate 2.
–
Verify that the drive shaft 1, in resting position, is 18.5 mm from the
front edge of the throat plate 2.
ATTENTION: Fragile, danger of breakage!
When the drive bar 5 is being adjusted, the fixing plate 6 for the
thread-cutting magnet must also be re-adjusted. See section 5.5.
4 3