Material Support Plate - Duerkopp Adler 558 Service Instructions Manual

19. Material Support Plate

1
2
3
The clearances X1 and X2 between the edges of the material support
plate and the hook block must be equal.
Caution Risk of Injury !
Pull the mains plug before setting.
–
Turn the machine out of the end position.
The roller bolt should not be on the cam 1.
–
Remove the needle plate and run the machine until in the turn-off
position.
–
Measure and compare the clearances X1 and X2.
–
With unequal clearances loosen the nut 3.
–
Set the roller bolt by turning the setting screw 2 accordingly.
–
Tighten nut 3 again.
–
Run the machine through and check the setting again outside of
the end position.
–
Lock setting screw 2.
25