Duerkopp Adler 558 Service Instructions Manual page 33

1
2
3
4
5
6
7
8
9
–
Position the clamping plates.
–
Turn on the main switch.
Caution Risk of Injury !
Do not reach into the area of the cutting knife with the machine turned.
–
Punch the seam pattern into thin cardboard with a short needle.
–
Check the position of the knife cut (see Illus. a).
–
Align the anvil body suitably and set the cutting knife accordingly.
–
Slide the stop 6 until touching the cutting knife and tighten.
–
Tighten screws 5 and 7 of the anvil body again.
–
Insert the upper control disc and cutting block for "cutting before
sewing".
–
Push the cutting knife by the difference x about 1 mm to the back.
–
Punch the seam pattern into thin cardboard with a short needle
again.
–
If necessary, correct the setting of the cutting knife lengthwise.
–
Slide the stop 2 until touching the cutting knife and tighten.
33