Duerkopp Adler 558 Service Instructions Manual page 34

1
2
34
Cutter bar
Before setting the cutter bar the anvil body must be aligned.
The knife impression should be at the center of the cutting block.
The cutter bar must move easily up and down but without any play.
Caution Risk of Injury !
Pull the mains plug before setting.
–
Loosen the lock nuts.
–
Align the cutter bar sideways by screwing the bearing screws 2 in
or out.
–
Tighten the lock nuts again.
–
Set the cutting block lengthwise so that the knife impression on the
cutting block reaches the given cutting length.
–
Slide the stop 1 until touching the cutting block and tighten.