Duerkopp Adler 558 Service Instructions Manual page 22

9 5
22
b) Cutting after sewing
The turn-off bolt 11 should release the high-speed wheel via the
reversing lever 8 when the cutting procedure is ended, this means,
when the cutter bar is in its highest position. The clamp closing lever 7
must be set to " cutting after sewing ".
Caution Risk of Injury !
Pull the mains plug before setting.
–
Turn the hand crank until the cutter bar is in its highest position.
In this setting, with open clamping plates, there must be a
clearance of about 4 mm between the closer 2 and the angle lever
10
1.
–
Loosen screw 5 and set the turn-off timing by adjusting the turn-off
bolt 11:
Machine switches too early - Turn-off bolt farther forward
Machine switches too late
6
–
Tighten screw 5 again.
–
Give the machine a run through and check the setting.
–
To arrest the setting pull stop 4 up to the turn-off bolt 11 and screw
4
tight.
11
1
2
3
4
5
6
7
8
- Turn-off bolt farther to the back