Brake Clamp - Duerkopp Adler 558 Service Instructions Manual

10. Brake Clamp

6
14
1
2
3
4
5
The brake clamp 2 brakes the feeding shaft 1.
The braking should thereby be only so strong that during running of
the machine the transport the material support plate occurs absolutely
uniform.
The setting of the braking force occurs through turning the pressure
screw 3.
Caution Risk of Injury !
Pull the mains plug before setting.
–
By sliding the transport lever 6 in direction of the arrow set the
greatest transport movement of the material support plate.
–
Turn the handwheel forward.
The transport lever moves up and the transport stroke is executed.
The lever 4 is moves onward by a certain amount.
–
Turn the handwheel to the back.
The transport lever moves down and the idle stroke is executed.
This movement should have no effect on the feeding shaft.
The lever 4 remains in its position !
–
Set the braking force accordingly by turning the pressure screw 3.
–
Tighten lock nut 5 again.