36.3 Feed Rod
1
2
3
When the lever 3 lies under the feed rod 1 in its rest position (upper
position) the clearance between the two must be 1 mm.
Caution Risk of Injury !
Pull the mains plug before adjusting.
–
Turn the hand crank until the hook block has turned by about 90 °.
Lock nut 2 is freely accessable in this position.
–
Tilt the machine head up.
–
Loosen lock nut 2.
Set the feed rod 1 higher for safety reasons.
–
Turn the hand crank farther until the hook block has turned by 180°.
In this position lever 3 is under feed rod 1.
–
Turn feed rod 1 until the clearance of 1 mm to the lever 3 is
reached.
–
Turn the hand crank until lock nut 2 is accessable.
–
Tighten lock nut 2 again.
55