Turn-On Link With Idle Lever - Duerkopp Adler 558 Service Instructions Manual

7. Turn-on Link with Idle Lever

1
2
3
4
5
For sure starting of the sewing drive the groove in the idle lever 4 must
freely enclose the pin of the roller screw.
When running into the turn-off position the turn-on link 1 is pressed so
far back by the stop 3 that the idle lever can fall in.
Caution Risk of Injury !
Pull the mains plug before setting.
–
Bring the material support plate by turning the hand crank into the
absolute end position.
The end position is reached when the material support plate no
longer moves to the rear.
–
Press the turn-on link 1 to the back.
The idle lever 4 falls downward.
–
Loosen screw 5.
–
Set the stop 3 to in front of the pin 2 of the roller screw.
Attention !
The pin may not be trapped in the groove of the idle lever.
–
Tighten screw 5 again.
11