Change Hook Thread Bobbin - Duerkopp Adler 510 Operating Instructions Manual

7.6 Change hook thread bobbin

3
1
2
Caution: Danger of injury !
Switch off main switch !
Change hook thread bobbin only when automatic bartacker
is switched off.
Take off empty bobbin
–
Pull down hook cover 3.
–
Lift bobbin case cover 1.
–
Take off top of bobbin case 2 with bobbin 6.
–
Remove empty bobbin from the top of the bobbin case 2.
Insert full bobbin
–
Place full bobbin in the top of bobbin case 2.
–
Thread bobbin thread through slot 5 below tension spring 7 in the
drill-hole 4.
–
Pull bobbin thread out of bobbin case 2 for a length of approx. 2.5 cm.
When winding off the thread the bobbin must turn in the direction of
arrow.
–
Reinsert bobbin case 2.
–
Shut bobbin case cover 3.
7
4
5
6
2
13
1