Sequence Programming Mode - Duerkopp Adler 510 Operating Instructions Manual

8.5.3.2 Sequence programming mode

32
In this menu item individual seam patterns are combined to retrievable
seam pattern sequences.
Totally 25 independent seam pattern sequences are available. Every
seam pattern sequence can be combined out of 20 seam patterns in
any order whatever.
–
Switch on the main switch.
The control is initialized.
The main menu appears.
–
Press function key "S" in the main menu.
The display changes over to the menu of the sequence
programming mode.
–
Select desired menu item with the keys "ñ" or "ò".
The menu line is displayed white on black.
–
Press key "ESC " or key "ò".
Back to the main menu.
Sequence number/ seam pattern sequence operation
Selection of the sequence to be created or to be altered.
When preparing a new programme, an asterisk (*) is indicated before
the number.
Input: 0 ... 25
–
Select desired sequence number with the keys "ñ" or "ò".
If the seam pattern sequence operation is to be switched off, select
the sequence number 0.
The sequence number is displayed white on black.
–
Press key "OK ".
The program is activated.
Seam pattern number (1 .. 20)
With this menu item you select the seam pattern number to be taken up
in the current sequence.
Input: 1 ... 51 (52 - 99 if available)