2.9 Reference position of the sewing motor
2.9.1
Position of the initiator
5
4
Caution: Danger of injury!
Switch off main switch.
Check and adjust initiator only when the button sewing automat is
switched off.
Standard checking
The distance between the initiator 1 and the largest outer diameter of
the 180° disc 3 should be as small as possible.
Correction of the distance between the 180° disc and the initiator
–
Loosen counternuts 4 and 5 at the initiator 1.
–
Set the smallest possible distance between initiator 1 and the
largest outer diameter of the 180° disc 3.
–
Tighten counternuts 4 and 5 at the initiator.
1
2
3
3
13