Assembly Of The Crank - Duerkopp Adler 510 Operating/Service Instructions Manual

2.2 Assembly of the crank

4 1
Caution: Danger of injury !
Switch off main switch.
Remove and mount crank only when the automatic bartacker is
switched off.
Standard
The crank 4 has to be mounted on the arm shaft 1 in such a way that
the pivot 3 of the screw 2 reaches into the drill-hole on the arm shaft.
The screw 2 is the first screw in the direction of rotation.
Assembly
–
Push crank 4 on arm shaft 1.
–
Twist crank 4 in such a way that its first drill-hole in the direction of
rotation lies above the drill-hole in the arm shaft 1. Insert screw 2
with pivot 3 and screw tight.
–
Insert screw 5 and tighten.
5
4
2
3
3
5