Adjust Bobbin Winder - Duerkopp Adler 510 Operating/Service Instructions Manual

2.5 Adjust bobbin winder

1
3
Caution: Danger of injury!
Switch off main switch.
Check and adjust bobbin winder only when the automatic bartacker is
switched off.
Standard
4
The bobbin winding operation must stop automatically when the bobbin
is filled up to approx. 0.3 mm below the edge of the bobbin.
Correction of the bobbin winder wheel
–
Loosen screws at the driver wheel 1.
–
Shift driver wheel 1 axially in such a way that it abuts on the bobbin
winder wheel 2 with the bobbin cover screwed on .
–
Tighten screws at the driver wheel 1.
The second screw in the direction of rotation is located at a
spot-faced place.
–
Put on head cover and tighten.
–
Check bobbin winder and repeat adjustment, if necessary.
Correction of the bobbin capacity
2
–
Loosen screw 3.
–
Adjust bobbin winder clip 4.
–
Tighten screw 3.
Note:
When correcting the driver wheel take care that the oil wicks do not
collide with the driver wheel afterwards.
1
1
3
9