2.7 Crankshaft drive to the hook shaft
2
4
1
Caution: Danger of injury!
Switch off main switch.
Check and adjust crankshaft drive only when the automatic bartacker
is switched off.
Standard checking
The arm shaft and the hook shaft are connected by the connecting rod
4 gripping into the crank 1 of the upper shaft.
The connecting rod 4 and the upper bearing shell 2 have a marking on
one side. When assembling them the markings must be on the same
side.
Connecting rod 4 and bearing shell 2 must not jam when being
screwed together.
–
Check whether the markings are on the same side.
–
Tighten screws 3 equally.
3
2
3
11