Oil Circulation - Duerkopp Adler 510 Operating/Service Instructions Manual

7.1 Oil circulation

40
4
From the filler pipe 1 the oil flows into the oil reservoir 2 and then it
runs over into the oil reservoir 3.
All lubricating points of the arm and head zone of the machine are
provided with oil by the oil reservoir 2. The oil reservoir 3 supplies all
lubricating points of the base plate.
The oil squirting off from the crankshaft drive comes into the oil pan via
oil wick 4.
The oil which is not needed by the hook flows back to the oil pan via
the return pipe 5.
The squirted oil contained in the oil pan is sucked and delivered back
to the oil reservoir 2 by means of a lubricating oil pump.
Caution: Danger of injury !
Switch off main switch.
Carry out assembly work on the oil circulation only when the
automatic bartacker is switched off
ATTENTION !
When carrying out assembly work please observe in any case that
the hose ends and wicks are fixed to the correct connections again.
5
1
2
3