lIghT BUlB aNd glaSS INSTallaTION
haRdWaRe (not to scale)
Glass Shade
install halogen Bulbs
Step 4. Screw the two bulbs into the light fixture as
shown in Figure #1.
iMPoRtant!
When installing a halogen
bulb, carefully cut off the end of the plastic
sleeve the bulb comes in and hold the bulb by
the plastic sleeve to screw it into the socket.
note: When replacing the bulbs, be sure to use only
50-watt maximum.
Glass installation
Step 5a. Align the glass shade up with the bottom of
the fan as shown in Figure #2 and locate the three
glass holding slots. Then locate the three glass hold-
ing tabs, located on the light fixture plate.
Step 5b. Carefully lift the glass globe up inside the
light fixture as far as it will go. Rotate the shade in a
counter clockwise direction as shown in Figure #3,
until the glass globe is held tightly in place by the
three tabs.
12
50 -watt
halogen Bulbs (2)
(Figure #1)
GLaSS
hoLdinG
taBS
GLaSS
Shade
(Figure #2)
(Figure #3)
GLaSS
hoLdinG
SLotS