Casablanca Isotope Owner's Manual page 16

Hide thumbs Also See for Isotope:
Table of Contents

Advertisement

To turn the lights off and on, press and release the
one second.
note: With CFL mode active, the lights will not dim.
To dim the down light, Press and hold the
The light will come on at the last brightness setting and increase in brightness
until full power is reached, then start dimming until the lowest setting is
reached. This cycle will repeat until you release the light button.
Note: The control with this fan has been shipped with CFL mode active .
Your fan has the ability to disable the dimming feature to allow the use of CFL bulbs.
To activate CFL mode:
1.  Turn the fan off by pressing the
2.  allow the fan to remain off for at least 5 seconds.
3.  Press the power button again to restore power to the fan.
4.  immediately press and hold the "1" and "3" buttons for at least 5 seconds. The fans lights will go to 100%
brightness and the dimming function will be disabled.
To cancel CFL mode:
5.  Turn the fan off by pressing the
6.  allow the fan to remain off for at least 5 seconds.
7.  Press the power button again to restore power to the fan.
8.  immediately press and hold the "2" and "4" buttons for at least 5
seconds. The fans lights will dim to 50% brightness and the dimming function will be enabled. Press
and hold the light buttons until the desired dimmer setting is reached.
You will only have to change the dip switch settings in the
remote if you are using more than one fan in the same
area and want to control them separately.
NOTE: DO NOT set dip switch setting in the remote
to '000000', this may cause frequency interference from
other Casablanca Products . All fans leave the factory set to
"111111"
16
oPeration lights
button for more than 1 second.
oPeration cfl MoDe
power button.
power button.
changing frequency setting
button for less than
Caution: CFL bulbs will not
function properly when
dimmed, which may result
in flickering or reduced bulb
life.
DiP
SWiTCHES
diP SWitCheS
Set to '111111'
(Factory Setting)
(Figure 1)
diP SWitCheS
Set to '000000'
Down Light

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents