List Of Error Causes And Corresponding Codes - Oki OF5900 Maintenance Manual

6.

List of Error Causes and Corresponding Codes

The table below lists the error causes likely to occur during PC loading and the corresponding
codes. When an error occurs, the corresponding error code is displayed, the buzzer sounds in
the corresponding pattern and transition to the permanent loop state occurs. (See Note 1.)
See "4. LCD Messages" and "5. Buzzer Sounding Patterns" for the LCD display and buzzer
sound upon occurrence of each error.
1 Timeout of data receiving waiting timer (14 seconds)
2 Loading data hash check error
3 Flash memory erase/write error
4 Disagreement between flash memory and external RAM contents (verify error)
5 Header sum check NG *1
6 Disagreement between loading machine type and machine identifier in header *1
7 Designation of unspecified parameter in header *1
8 Extended address record sum check NG *2
9 Data record sum check NG *2
10 Start address record sum check NG *2
11 File end record sum check NG *2
12 Timeout by failure in normal data receiving for 1 minute in loading waiting state after
operation
13 RAM check result NG upon starting loading program processing
33 The data reception wait timer (14 seconds) has expired during data transfer from the PC
to the MFP main unit.
34 A received data hash check error has occurred in the MFP main unit.
35 On the G4 board side, an error has occurred during flash memory data erasure/write.
36 On the G4 board side, updated flash memory contents do not mach the contents of
source DRAM.
37 The G4 board has detected setting of an invalid value in the DPRAM length area on the
MFP main unit side.
38 The G4 board has detected setting of an invalid value in the DPRAM status area on the
MFP main unit side.
39 Reserved
40 On the MFP main unit side, normal data has not been received for one minute after start
of G4 board PC loading.
41 On the G4 board side, a header sum check error has occurred.
42 On the G4 board side, a loading data hash check error has occurred.
43 On the G4 board side, a header parameter specification error has occurred.
44 On the MFP main unit side, the G4-board-side DPARM status response state has been
maintained for 3 minutes or longer.
45 On the G4 board side, a DRAM check error has occurred.
46 The MFP main unit has detected setting of an invalid value on the G4 board side.
47 On the G4 board side, the local machine type does not match the header's type
identifier.
OKIFAX 5700/5900 G - 13
CODE
00
01
02
03
04
05
06
07
08
09
0A
0B
0C
20
21
22
23
24
25
26
27
28
29
2A
2B
2C
2D
2E