HP FM064UT#ABA Maintenance And Service Manual page 214

Table 6-10
Screen message
213—Incompatible Memory
Modules
214—DIMM Configuration
Warning
215—DIMM Configuration
Error
216—Memory Size Exceeds
Maximum Supported
301—Keyboard Error
303—Keyboard Controller
Error
304—Keyboard or System
Unit Error
510—Splash Screen image
corrupted
511—CPU Fan not detected
512—Rear Chassis fan not
detected
202 Chapter 6 Diagnostics and troubleshooting
POST error messages (continued)
Probable cause
A memory module in the memory
socket identified in the error message
is missing critical SPD information, or
is incompatible with the chipset.
DIMMs are not installed correctly (not
paired correctly).
The amount of memory installed
exceeds that supported by the
hardware.
Keyboard failure.
I/O board keyboard controller is
defective or is not set properly.
Keyboard failure.
Splash Screen image has errors.
Fan is not connected or is defective.
Rear fan missing, disconnected, or
defective.
Recommended action
1. Verify the memory module type.
2. Insert the DIMM in another memory socket.
3. Replace the module with a DIMM conforming
to the SPD standard.
See the service label on the workstation access panel
for the correct memory configurations, and reseat the
DIMMs accordingly.
1. Verify how much memory the workstation
supports.
2. Remove the excess memory.
1. Reconnect the keyboard with the workstation
powered off.
2. Check the connector for bent or missing pins.
3. Be sure that none of the keys are pressed.
4. Replace the keyboard.
1. Reconnect the keyboard with the workstation
powered off.
2. Connect a keyboard directly to the workstation
(instead of through a switch box).
3. Replace the system board.
1. Reconnect the keyboard with the workstation
powered off.
2. Connect a keyboard directly to the workstation
(instead of through a switch box).
3. Be sure that none of the keys are pressed.
4. Replace keyboard.
5. Replace system board.
Update system BIOS.
1. Reseat the fan cable.
2. Reseat the fan.
3.
Replace the fan.
1. Reseat the fan cable.
2. Reseat the fan.
3. Replace the fan.
ENWW