HP FM064UT#ABA Maintenance And Service Manual page 52

Table 4-1 Computer Setup (F10) Utility menu descriptions (continued)
Heading
Advanced
2
40 Chapter 4 System management
Option Description
Power-On Lets you set the following:
Options
POST Messages—Enables or disables the splash screen during POST.
●
● F9 Prompt (Displayed or Hidden)—Selecting Displayed displays the F9=Boot Menu
during POST. Selecting Hidden prevents the text from being displayed. However, pressing
F9 still accesses the boot menu.
● F10 Prompt (Displayed or Hidden)—Selecting Displayed displays F10=Setup during
POST. Selecting Hidden prevents the text from being displayed, but pressing F10
still accesses the Setup screen.
F12 Prompt (Displayed or Hidden)—Selecting Displayed displays F12=Network
●
Service Boot during POST. Selecting Hidden prevents the text from being displayed
but pressing F12 still forces the workstation to attempt booting from the network.
● Option ROM
display a message before loading options ROMs.
Remote Wakeup Boot Source—Enables you to set the remote wakeup boot source as:
●
Local Hard Drive
◦
◦ Remote Server
● After Power Loss (On, Off, Previous State)—Enabling this option directs the previous state to
be the default.
POST Delay (in seconds) (5, 10, 15, 20, None)—Adds a specified delay to the POST
●
process. This delay is sometimes needed for hard disk drives on some expansion cards that
spin up slowly (so slowly that they are not ready to start by the time POST is finished). The
POST delay also gives you time to select F10 to enter the Computer Setup (F10) Utility.
BIOS Power-On Lets you disable or specify a weekday and time for BIOS power-on.
Processors Enables/disables these options:
● Hyper-Threading—Provides processor parallelization such that the operating system treats
one processor as two.
Active Cores (1,2, or All Cores)—Selects a single core, or multiple cores per socket. (Not
●
available on some configurations.)
Limit CPUID Maximum Value to 3 (Enable or Disable)—Sets the number of allowable CPU
●
IDs.
Onboard Lets you set resources (IRQ, DMA, I/O Rate) or disable onboard system devices such as serial port
Devices and diskette controller. Operating system parameters generally override Onboard Devices
settings.
PCI VGA Configures which expansion slots are used for graphics cards. In multi-graphics card
Configuration configurations, this option designates one graphics card as primary and the other card as
secondary.
prompt (Enable or Disable)—Enabling this feature causes the workstation to
1
ENWW