HP FM064UT#ABA Maintenance And Service Manual page 136

4. Remove the expansion card support, if installed. Some workstation models use a bar support;
remove the two screws (1) and lift up on the support (2).
Figure 5-49
Other workstation models use a hold down clamp; grasp the top of the clamp (1), squeeze the
release handles until the bottom of the clamp releases from the clamp rail (2) (it should click when
it releases), and swing the clamp out from the back panel (3).
Figure 5-50
5. Remove all cables connected to the expansion card.
124 Chapter 5 Replacing components
Removing expansion card support
Removing expansion card clamp
ENWW