CHAPTER 4
3. Cleaning Page
When the dirty fixing unit is the cause of image defect, the fixing unit can be cleaned by the user.
The toner on the upper pressure roller can be removed by printing the cleaning pattern in fig-
ure 4-1-4 and re-feeding the paper (cleaning page). The procedure is as shown below.
1) Go to the "CLEANING PAGE" item in the TEST MENU.
2) Press the Enter/Cancel key.
3) The message "LOAD <size> IN MANUAL" is displayed (Because the data requests Manual feed
mode.) [Note]
4) Load a paper requested in the multi-purpose tray.
5) Press the Go key.
6) CLEANING PAGE is created at 600dpi.
7) The message "LOAD CLEANING PAGE IN MANUAL" is displayed after delivering paper.
4 - 8
•
Load this sheet, this side down, in MPT
•
Læg dette ark, med denne side nedad, i universalbakke
•
Laad dit vel met deze kant naar beneden in MPT
•
Lattaa tämä arkki, tämä puoli alaspäin, MPT:hen
•
Introduire cette page, ce côté vers le bas, dans le tiroir polyvalent
•
Legen Sie dieses Blatt mit dieser Seite nach unten in den MPT ein
•
Caricare questa pagina, con questa facciata verso il basso, nel MDT
•
Legg i arket med denne siden ned i den manuelle materen
•
Coloque esta página, com este lado para baixo, no MPT
•
Cargue esta hoja en MPT, con esta cara hacia abajo
•
Lägg detta ark med textsidan nedåt på din MPT
Figure 4-1-4