CHAPTER 3
6. Removal of the duplexing unit driver
PCB
1) Remove the 6 screws and then the
upper feed guide.
Screws
Upper feed guide
Figure 3-10-10
2) Remove the screw and then lower feed
guide, then disconnect the connector on
the PCB.
Screw
Lower feed guide
Figure 3-10-11
3 - 42
3) Disconnect the 6 connectors.
4) Unhook the claw and pull out the
duplexing unit driver PCB.
Connectors
Claw
Duplexing unit driver PCB
Figure 3-10-12