C. Video Controller PCB
1) Remove the right rear cover.
2) Remove the 5 screws and slide the
shield case in the direction of the arrow
to remove it.
Screws
Shield case
Figure 3-7-7
3) Remove the 7 screws, and then the
video controller PCB.
Screws
Video controller PCB
Figure 3-7-8
Note:
The paper size default of the service
part video controller PCB is Letter.
Therefore, make sure to change it
to A4 by turning ON the printer
with the Menu, Item, and Value
CHAPTER 3
keys pressed simultaneously after
replacing the 200V model video
controller PCB.
3 - 29