Copy; Copying Procedure; Load The Documents - Xerox WorkCentre 5225 User Manual

3 Copy

This chapter contains information on the copy screens and the features available.
NOTE: Some of the features described in this chapter are optional, and may not apply
to your machine configuration.

Copying Procedure

This section describes the basic copy procedure. Follow the steps below.
1. Load the Documents – page 45
2. Select the Features – page 47
3. Enter the Quantity – page 48
4. Start the Copy Job – page 48
5. Check the Status of the Copy Job – page 48
Stopping a Copy Job – page 49
NOTE: If the Authentication and Accounting feature is enabled, you may be required
to enter your user ID and passcode (if they are set up) before using the machine. For
further information, contact the System Administrator.

1. Load the Documents

The machine provides the following document input areas:
• Document feeder - for single or multiple-page documents
• Document glass - for single-page or bound documents
NOTE: The document glass cover will be installed in the non-document feeder
configuration.
NOTE: The machine automatically detects standard document sizes. The sizes that
can be detected vary depending on the paper size table specified by the System
Administrator. For more information on setting the paper size table, refer to the Setups
chapter in the System Administration Guide. If the document is of a non-standard size
or not identified as a standard size, the machine will prompt you to check the
document or manually enter the document size. For information on how to enter a
document size manually, refer to
Original Size on page 59
.
45