Handling Static-Sensitive Devices - IBM x3650 - System M2 - 7947 User Manual

v Remove jewelry, such as bracelets, necklaces, rings, and loose-fitting wrist
v Remove items from your shirt pocket, such as pens and pencils, that might fall
v Avoid dropping any metallic objects, such as paper clips, hairpins, and screws,

Handling static-sensitive devices

Attention:
To avoid damage, keep static-sensitive devices in their static-protective packages
until you are ready to install them.
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions:
v Limit your movement. Movement can cause static electricity to build up around
v The use of a grounding system is recommended. For example, wear an
v Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
v Remove the device from its package and install it directly into the server without
v Take additional care when handling devices during cold weather. Heating reduces
38
System x3650 M2 Type 7947: Installation and User's Guide
watches.
into the server as you lean over it.
into the server.
Static electricity can damage the server and other electronic devices.
you.
electrostatic-discharge wrist strap, if one is available. Always use an
electrostatic-discharge wrist strap or other grounding system when working inside
the server with the power on.
metal surface on the outside of the server for at least 2 seconds. This drains
static electricity from the package and from your body.
setting down the device. If it is necessary to set down the device, put it back into
its static-protective package. Do not place the device on the server cover or on a
metal surface.
indoor humidity and increases static electricity.